Garbage Disposal Repair, Replacement and Installation in DFW

Humming, leaking or dead? We’ll get it grinding again.

A garbage disposal rarely dies quietly. It hums and won’t spin, it leaks all over the cabinet, or it does nothing at all when you flip the switch. CR Plumbing, Air and Electric repairs and replaces disposals for homes across Denton, Lewisville, Flower Mound, Argyle, Fort Worth, Plano and McKinney, and most jobs are finished in a single visit.

Our plumbers carry parts for the most common repairs, and because we’re licensed electricians too, a dead outlet or a hardwired unit under the sink doesn’t turn into a second appointment.

mainstage v1 alt img.2209291349206

Same-Day Availability

A kitchen sink you can’t use is a real problem, especially once water starts backing up. We try to get to you the same day you call.

Licensed Plumbers and Electricians

Licensed plumbers who follow Texas code and the manufacturer’s install instructions. We do electrical work too, so a missing or dead outlet under the sink gets fixed on the same visit.

All Major Brands

InSinkErator, Moen, Waste King, GE, Whirlpool and most others. We work on all of them and carry the parts for the most common repairs.

Clean Job Guarantee

Drop cloths down, the mess kept under the sink, and the old unit hauled away. You get your kitchen back the way you left it, minus the broken disposal.

What’s Actually Wrong With Your Disposal

Most disposal problems come down to a handful of causes, and the symptom usually points to which one. If it hums but won’t spin, something is jammed between the flywheel and the grind ring, or the motor is starting to seize. If it does nothing at all, the reset button on the bottom may have tripped, or the problem is the switch, the outlet or the breaker.

With leaks, where the water shows up tells you a lot. A leak at the top usually means the sink flange seal has failed, which is fixable. A leak at the side is usually the dishwasher hose or the drain connection. A leak from the very bottom of the unit means the internal seal has worn through, and at that point the disposal needs replacing.

 

mainstage v1 alt img.2209291349206

We’ll tell you which one you’re dealing with, and the price, before any work starts. Most repairs and replacements are finished on the same visit.

What It’s DoingUsual CauseRepair or Replace?
Hums but won’t spinJam between the flywheel and grind ring, or a seizing motorRepair if it’s a jam. Replace if the motor is going.
Does nothing at allTripped reset button, breaker, switch or outletUsually a repair, often a quick one
Keeps tripping the breaker or reset buttonA jam or an overloading motor, or a failing motorRepair if it’s a jam, otherwise replace
Leaks at the top, under the sinkFailed sink flange seal or loose mountingRepair
Leaks at the sideDishwasher hose or drain connectionRepair
Leaks from the bottomWorn internal sealReplace
Drains slowly or backs upClog in the trap or drain line past the disposalRepair, sometimes a drain cleaning
Grinds loudly or rattlesSomething hard inside, or loose or worn mountingRepair, unless the grind parts are worn out
Smells bad no matter whatFood buildup under the splash guard and in the chamberA cleaning, not a repair

 Try This Before You Call

A few disposal problems are worth a five-minute check yourself. Always turn the disposal off at the switch, and unplug it or flip the breaker, before you touch anything.

  • Press the reset button. It’s the small red button on the bottom of the unit. If the motor overheated, it trips to protect itself. Wait a few minutes, press it, and try again.
  • Free a jam with a hex key. Most disposals have a socket in the center of the bottom that takes a 1/4 inch hex key, and many come with one. Work it back and forth until it turns freely, then lift any loose debris out from the top with tongs or pliers. Never with your hand.
  • Check the breaker and outlet. If there’s no hum at all, check the breaker, and check whether the under-sink outlet runs through a GFCI outlet somewhere else in the kitchen that has tripped.
  • Skip the chemical drain cleaner. It can damage the disposal’s seals, and it leaves caustic water sitting in the unit for whoever opens it up next.

If it still hums, still won’t turn on, or is leaking, that’s the time to call us.

Why Homeowners Choose Us

  1. Licensed Technicians. Plumbers who install and fix disposals every week, not a handyman trying one for the first time.
  2. Transparent Pricing. You see the price before we touch anything. If replacing costs less than repairing, we’ll say so.
  3. Fast Turnaround. Most jobs take one trip, usually an hour or two.
  4. Built to Last. Correct mounting, sealed connections and the right size unit. That’s what keeps a disposal from rattling loose or leaking a year later.
  5. Clean and Respectful Service. Drop cloths down, cabinet wiped out, and the old unit leaves with us.

Should You Repair or Replace Your Garbage Disposal?

Repair makes sense when the unit is fairly new and the problem sits outside the motor: a jam, a tripped reset, a leak at the sink flange or at one of the connections. Those are usually quick fixes.

Replacement makes more sense when:

  • It leaks from the bottom or the body of the unit
  • The motor hums, overheats or trips constantly even after a jam is cleared
  • It’s past about 8 to 10 years old and starting to need repeat visits
  • The repair would cost more than about half the price of a new installed disposal
  • It’s too small for your household and jams every week

Check the warranty before you pay for anything. Many disposals carry multi-year warranties, and some brands replace a failed unit outright. Give us the model and we’ll tell you whether it’s still covered.

Garbage Disposal Installation and Replacement

Swapping a disposal looks simple on paper. In practice, the mounting ring on the old one rarely matches the new one, the drain arm sits at a different height, and the old unit may have been hardwired instead of plugged in. That’s usually where DIY installs stall.

When we install one, we replace the mounting assembly so it seals properly to your sink, line up the drain so it won’t leak or back up, connect the dishwasher, and get the power right, whether that’s an outlet under the sink or a hardwired connection. Then we run water through it and check every joint before we leave.

Choosing the right size

Size matters more than brand. A 1/3 horsepower unit is fine for one or two people who don’t cook much. Most families of four are better off with 1/2 horsepower, and a household of five or six, or one that cooks a lot, should look at 3/4 horsepower or more. Bigger units grind finer, jam less and usually run quieter. We’ll help you choose if you’re not sure.

Homes on septic

Plenty of acreage homes around Argyle, Bartonville and Double Oak are on septic. A disposal still works with a properly maintained septic system, and septic-rated models add bacteria and enzymes that help break down food waste in the tank. If you’re on septic, tell us and we’ll recommend one of those.

What not to put down it

Grease, bones, big batches of potato peels, lots of coffee grounds, and stringy food like celery or corn husks. Most of the clogs we clear started with one of those. Run cold water while it grinds and for a few seconds after, so the waste actually makes it down the line.

How Much Does Garbage Disposal Repair or Replacement Cost?

These are typical ranges. You’ll get your exact price before any work starts.

JobTypical Cost
Repair (jam, reset, connection leak)Often $100 to $250 in labor, plus parts if needed
Replace an existing disposal with a standard unit$200 to $625 installed
Higher-horsepower or stainless steel unitThe unit alone can run $400 to $1,100, plus installation
New disposal where there wasn’t one before$250 to $650, plus an outlet or switch if the sink has no power

What moves the price: the horsepower and model you choose, whether the mounting hardware or drain needs changing, whether power has to be added under the sink, and whether a dishwasher connection is involved. If a repair would cost close to what a new disposal costs, we’ll tell you.

Garbage Disposal Repair Near You

We repair, replace and install garbage disposals across North Texas from six locations:

Frequently Asked Questions

Humming without spinning, loud grinding or rattling, water under the sink, slow draining, a smell that won’t clear, or a reset button that keeps tripping. Any of these is worth a look before the unit fails completely.

Yes, usually on the same visit. We remove the old unit, fit new mounting hardware, connect the drain and dishwasher, and haul the old one away.

Something is jammed, or the motor is starting to fail. Turn off the power, work a hex key in the socket on the bottom back and forth, press reset and try again. If it still hums, call us, because running a jammed motor can burn it out.

Yes. We find the real source, whether that’s the disposal, the drain, the dishwasher line or the sink flange, and fix that instead of guessing.

Usually 8 to 15 years, depending on the model and how hard it works. Heavier stainless steel units tend to last the longest.

Yes, and a plumber is usually who you want, because most disposal problems involve the drain, the sink seal or the dishwasher connection. We’re also licensed electricians, so if the problem turns out to be the outlet or the switch, we fix that too.

The internal seal has worn out. That isn’t repairable, so the fix is a new disposal, which we can usually install on the same visit.

Press the red reset button on the bottom, check the breaker, and look for a tripped GFCI outlet. If it still won’t respond, the switch, outlet or motor has likely failed, and we can handle both the plumbing and the electrical side in one visit.

If the new unit uses the same mounting system and plugs in, a handy homeowner can. Where it usually goes wrong is a mismatched mounting ring, a drain at the wrong height, a hardwired unit, or forgetting to knock out the dishwasher plug.

Yes, as long as the septic system is maintained. We’d usually recommend a septic-rated model that adds bacteria and enzymes to help break down food waste.

How it Works

01

Assessment

We find out what’s actually wrong: a jam, the motor, a seal, the drain or the power.

02

Repair or Install

You get the price first. Then we clear, repair or replace, and connect the drain, dishwasher and power properly.

03

Quality Check

We run water through it, grind a test load, and check every connection for leaks before we leave.

CONTACT FORM
map

Flower Mound

3121 Cross Timbers Rd #11 Flower Mound, TX 75028

North Richland Hills

4925 Davis Blvd Suite 201 North Richland Hills, TX 76137

Richland Hills

3113 Elm Park St. Richland Hills, TX 76118

Argyle, TX

2231 Berniece Jones Rd. #103 Argyle, TX 76226